Installation Instruction Billet VW with Ignitor
1. Install the original distributor hold-down clamp onto the billet distributor housing. The clamp should sit flat against the distributor collar. 2. Remove the Flame-Thrower billet distributor cap. 3. Turn the distributor drive tang so that it lines up with the distributor driveshaft slot. 6. Place the distributor cap onto the housing. 7. Turn the housing so that the terminal, that represents the first cylinder in the firing order, lines up with the rotor contact terminal.
8. Tighten the hold down and slightly tighten the distributor clamp. Once the ignition timing is adjusted the distributor clamp should be tightened completely.
