If you searching for BMW R1150GS Fitting Instructions Hepco & Becker Engine Bars, you come to the right place. Here you can read or download the article directly from the official website. This BMW R1150GS Fitting Instructions Hepco & Becker Engine Bars user manual, user guide, instruction manual, how to instruction, service manual or repair manual is provided by the manufacturer, and you will read or download from their server.
You can read or download BMW R1150GS Fitting Instructions Hepco & Becker Engine Bars below. In addition to providing this file, we also provide user guide, drivers and software of any brand. Check any other articles by browse all content of this site.
Download link is loading from the server
Please wait 22 seconds.
BMW R1150GS Fitting Instructions Hepco & Becker Engine Bars
Preparation for fitting The bars can be fitted without removing the tank but it must at least be moved backwards a few inches. This is very simple. However, the job is much easier if you can remove the tank entirely. These instructions assume that you have not done this and will simply slide the tank backwards. Gently lift the rear end of the tank and slide it backwards until the brackets on either side (under the tank) clear their holders.
If you’ve never done this before, don’t worry, it’ll be clear what is meant once you start. The tank can now be held either side and moved as desired backwards a few inches or twisted slightly to allow access for the front fixing bolt. Remember: the fuel lines are still attached, so don’t try to move it too far! It’s OK to rest the tank gently on the fuse boxes but it’s best if the tank is not full with petrol! The front fixing position uses the original 6mm allen headed bolts that hold the instrument panel subframe to the main frame.
